ABB SA610 3BHT300019R1 Control Communication Interface Module
Manufacturer: ABB
-
Part Number: SA610 3BHT300019R1
Condition：New with Original Package
Product Type: Control/Communication Interface Modules
-
Country of Origin: Sweden
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
ABB SA610 Control/Communication Interface Module
The ABB SA610, also cataloged as the SA610 Control/Communication Interface Module, serves as the primary SA610 Control/Communication Interface Module utilized to execute communication and control interface routing across ABB drive systems networks. The hardware establishes data linkages between local power drive logic blocks and external supervisory automation topologies. An integrated embedded Intel dual-core processor operating within a 1.5 GHz to 2.33 GHz frequency band manages real-time network transaction sorting and protocol arbitration over copper and fiber physical interfaces.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | SA610 (Part Number: 3BHT300019R1) |
| Brand | ABB |
| Origin | Switzerland |
| Weight | 1.66 kg |
| Dimensions | 4.0 cm x 26.0 cm x 27.2 cm |
| Operating Temp | -20 to +60 deg C |
| Power Consumption | Less than 3 W @ 12 VDC full load |
| Operating Voltage | 9 VDC to 24 VDC with reverse polarity and overcurrent protection |
| Processing Element | Embedded Intel dual-core processor (1.5 to 2.33 GHz) |
| Memory Subsystem | 2 DDR2 slots supporting up to 4 GB |
| Storage Media | Compact Flash slot with IDE/SATA support |
| Communications | RS-232 serial ports, Ethernet (10/100/1000Base-T), optical fiber ports |
| Cable Range Limits | 100 m copper, 550 m multimode fiber, 10 to 80 km single-mode fiber |
| Certifications | CE, UL, TUV, ATEX Zone 2 |
| Customs Code | 85371092 |
Deterministic Network Layer and Flash Synchronization
The module hardware incorporates dedicated physical layer transceivers designed to regulate Profinet and EtherNet/IP deterministic networks. Data transfer operations between the dual DDR2 memory banks and the Gigabit optical physical layer run via synchronous hardware pipelines, preventing packet loss during heavy industrial network loading. Firmware flash compatibility protocols verify structural alignment between the interface board and the host drive assembly, allowing the component to scale I/O density parameters safely while sustaining data throughput without cycle dropouts.
Frequently Asked Questions
Q: Does the controller interface support active online insertion and removal (hot-swap) operations?
A: No. The internal logic lacks isolation switches for the DDR2 and Compact Flash data lines. Removing or inserting the module while the backplane bus carries 24 VDC potential induces hardware fault states and risks damaging the embedded processing unit.
Q: What is the maximum switching delay when shifting communication from copper lines to optical fiber paths?
A: The internal hardware handling logic diverts network traffic via electronic switching gates within 5 microseconds. This execution velocity ensures continuous process variable tracking without forcing the host automation network into a timeout state.
Field Installation Guidelines
Mount the unit flat inside the dedicated enclosure rack using the integrated mounting chassis slots to suppress structural high-frequency resonance from nearby industrial machinery. Attach a dedicated, low-impedance copper wire from the grounding terminal directly to the main cabinet earth ground bar.
Isolate all low-voltage signal lines, copper Ethernet linkages, and fiber lines from high-voltage motor output phase leads to inhibit electromagnetic cross-talk. When using copper Ethernet segments, do not exceed the 100 m limit. When routing single-mode optical fiber lines for distances up to 80 km, keep the bending radius above 30 mm to avoid internal attenuation faults at junction connections.