Analog/Digital Input Interface Board GE IS200ADIIH1AAA Mark VI
Manufacturer: GE Fanuc
-
Part Number: IS200ADIIH1AAA
Condition：New with Original Package
Product Type: Analog Output Module for CENTUM
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE IS200ADIIH1AAA Analog/Digital Input Interface Board
The GE IS200ADIIH1AAA, also cataloged as the IS200ADIIH1AAA Analog/Digital Input Interface Board, operates as a dedicated hardware component for high-precision signal acquisition and analog-to-digital conversion within GE Mark VI Speedtronic turbine control networks.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | IS200ADIIH1AAA |
| Brand | GE Mark VI Speedtronic |
| Origin | USA |
| Weight | 0.45 kg |
| Dimensions | 12.0 in x 8.0 in (30.48 cm x 20.32 cm) |
| Operating Temp | -30 deg C to 65 deg C |
| Power Consumption | Backplane dependent |
| Performance | Analog to Digital signal conversion |
Backplane Bus Communication and Firmware Architecture
The IS200ADIIH1AAA utilizes high-speed internal bus communication protocols to transmit digitized sensor data to the primary control processor within the Mark VI rack. This module executes signal processing via onboard analog-to-digital converters, ensuring synchronization with the system scan time. Its firmware supports flash-based updates, allowing for compatibility with diverse controller logic configurations while maintaining deterministic bus communication velocity. The architecture optimizes I/O density by multiplexing multiple analog sensor channels, facilitating real-time feedback loops required for turbine regulation and monitoring.
Frequently Asked Questions
Q: Is the IS200ADIIH1AAA compatible with hot-swap operations in the Mark VI rack?
A: No, system power must be disconnected from the specific rack segment before removing or inserting this module to prevent bus backplane damage.
Q: How does the module maintain signal integrity during data conversion?
A: The board employs galvanic isolation and input noise filtering to suppress electromagnetic interference and transients, ensuring accurate conversion of low-level analog signals into digital formats.
Field Installation Guidelines
Install the IS200ADIIH1AAA by aligning the board edge connector with the corresponding slot on the Mark VI backplane. Ensure the module is seated fully to maintain backplane bus contact. Grounding is achieved through the mechanical attachment to the rack chassis; confirm the integrity of these mounting points to provide a low-impedance path for noise drainage. Route analog signal cabling separately from high-voltage power lines to minimize induced noise. Upon installation, verify the status LEDs on the module faceplate to confirm operational handshake with the processor.