Communication Card | GE DS200TCQCG1BFE Mark V
Manufacturer: GE Fanuc
-
Part Number: DS200TCQCG1BFE
Condition：New with Original Package
Product Type: Communication Modules
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE DS200TCQCG1BFE Mark V Speedtronic Quad Communication Board
The GE DS200TCQCG1BFE, also cataloged as the DS200TCQC Quad Communication Board, operates as a dedicated hardware component for signal routing, communication synchronization, and peripheral data exchange within Mark V Speedtronic platforms.
Suffix Breakdown & Model Matrix
| Base Model | Board Identifier | Functional Revision | Artwork / Firmware Revision |
|---|---|---|---|
| DS200 | TCQC | G1 | BFE |
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | DS200TCQCG1BFE |
| Brand | GE (General Electric) |
| Origin | USA |
| Weight | 0.254 kg |
| Dimensions | 330 x 280 x 50 mm |
| Operating Temp | 0 to 60 deg C |
| Power Consumption | Dependent on backplane load |
| Product Type | Quad Communication Board (TCQC / RST Overflow Board) |
| Operating Voltage | 24 VDC (from system PSU) |
| System Compatibility | GE Mark V Turbine Control System |
| Physical Form Factor | Standard Mark V rack size board |
| Hardware Protection | Integrated fuse protection with monitoring circuit |
| Diagnostic Display | Onboard status and fault indication LEDs |
| Interface Topology | Backplane bus and serial communication ports |
Deterministic Backplane Communications & Network Execution
The board manages quad-channel communication routing across the Mark V backplane bus to ensure real-time data execution. Embedded logic handles communication synchronization and local signal routing without increasing processor latency. Onboard diagnostic LEDs continuously monitor bus traffic and power status, while hardware jumpers allow technicians to adjust serial line timing and communication parameters.
Frequently Asked Questions
Q: Can the DS200TCQCG1BFE board be swapped while the Mark V rack is energized?
A: No. Operating personnel must completely isolate system power before extracting or seating the board. Hot-swapping risks damaging sensitive backplane bus components and corrupting active communication channels.
Q: How are communication timing and address settings configured on the DS200TCQCG1BFE?
A: Onboard jumpers and switches control serial line timing, address assignment, and communication routing parameters. Technicians must match these jumper configurations to the system engineering drawings prior to installation.
Q: What indicates an internal electrical protection fault on the board?
A: Integrated onboard fuses protect the 24 VDC distribution paths. A blown fuse triggers an illuminated diagnostic LED on the board edge, signaling a circuit fault to maintenance personnel.
Field Installation Guidelines
- Disconnect all primary power supplies feeding the Mark V card cage before beginning replacement procedures.
- Wear an ESD grounding wrist strap attached to the cabinet ground stud to prevent electrostatic damage during module handling.
- Verify that all onboard jumper positions match the exact configuration of the replaced board before inserting it into the rack.
- Align the board along the card cage guide rails and seat it firmly into the backplane connector before tightening the retention hardware.