DS200TCQAG1BD GE Mark V TCQA Analog Board
Manufacturer: GE Fanuc
-
Part Number: DS200TCQAG1BD
Condition：New with Original Package
Product Type: Analog Input Modules
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE DS200TCQAG1BD Mark V Speedtronic Analog I/O Board
The GE DS200TCQAG1BD, also cataloged as the DS200TCQA Analog I/O Board, operates as a dedicated hardware component for analog signal acquisition and signal conditioning within Mark V Speedtronic platforms.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | DS200TCQAG1BD |
| Brand | GE (General Electric) |
| Origin | USA |
| Weight | 0.67 kg |
| Dimensions | 100 x 80 x 20 mm |
| Operating Temp | -40 deg C to +70 deg C |
| Power Consumption | Dependent on backplane load |
| Product Type | TCQA Analog Input/Output Board |
| Microprocessor | Intel 80196 |
| Firmware Storage | Onboard PROM modules |
| Input Voltage | 24 VDC |
| Input Signal Types | Analog (4-20 mA or RTD) |
| Core Ribbon Connectors | JCC and JDD (50-pin connectors) |
| Auxiliary Ribbon Connectors | 2PL, 3PL, JHH, JII, JMP, JKK, JTEST, TCQPL |
| Configurable Jumpers | JP1, JP2, JP3 for hardware configuration |
Deterministic Backplane Communications & Firmware Execution
The board manages real-time backplane bus communication velocity and deterministic processing via its onboard Intel 80196 16-bit microcontroller. Integrated PROM modules store firmware execution routines directly on the circuit assembly, enabling low-latency conversion of field sensor variables. Jumper blocks JP1, JP2, and JP3 modify signal paths and line burden parameters prior to digital transmission across the primary backplane bus.
Frequently Asked Questions
Q: How do the onboard PROM firmware chips impact module replacement on the DS200TCQAG1BD?
A: Firmware flash compatibility and revision levels reside in physical PROM sockets on the board. When replacing an existing unit, technicians must ensure that firmware revision codes match system controller parameters or transfer existing socketed PROMs to the replacement board.
Q: Are hot-swap procedures supported when replacing the DS200TCQAG1BD in an active rack?
A: No, hot-swapping is not permitted. Isolating all 24 VDC power and field input signals is required before disconnecting the 50-pin JCC and JDD ribbon cables or extracting the card from the card cage.
Q: What function do connectors JCC and JDD serve on this module?
A: Connectors JCC and JDD are 50-pin ribbon cable interfaces that route conditioned analog signals and backplane communication lines directly between the TCQA board and central processing core units.
Field Installation Guidelines
- Disconnect all main power feeds to the card rack before removing or inserting the board assembly.
- Wear a grounded electrostatic discharge (ESD) wrist strap attached to the cabinet chassis during handling.
- Verify that jumper switches JP1, JP2, and JP3 match the pin configuration of the original board before restoring power.
- Align the board edges strictly along the card cage guide tracks and torque all retention screws to secure cabinet grounding continuity.