Emerson VE4006P2 Serial Card | New & Original Stock
Manufacturer: Emerson
-
Part Number: VE4006P2 KJ3241X1-BA1
Condition：New with Original Package
Product Type: Serial Interface Cards
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
Emerson VE4006P2 DeltaV DCS Module
The Emerson VE4006P2, also cataloged as the KJ3241X1-BA1 Redundant Serial Interface Card, operates as a dedicated hardware component for fault-tolerant external serial device telemetry within Emerson DeltaV DCS networks.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | VE4006P2 |
| Brand | Emerson |
| Origin | USA |
| Weight | 1.81 kg (4.00 lbs) |
| Dimensions | 248 mm x 40 mm x 226 mm |
| Operating Temp | -40 to +70 deg C |
| Storage Temp | -40 to +85 deg C |
| Power Consumption | Base backplane power requirement |
| Product Type | Redundant Serial Interface Card |
| System Compatibility | DeltaV DCS |
| Communication Ports | 2 serial ports (RS-232 and RS-422/485) |
| Redundancy | Automatic failover between ports |
| Baud Rate Range | 300 to 115,200 bps |
| Humidity Range | 5% to 95%, non-condensing |
| Certifications | CE |
Process Control and DCS Instrumentation Features
The hardware platform incorporates localized channel-to-channel isolation between data channels to block transient voltage spikes from affecting adjacent communications or the primary backplane bus. It manages data transfers from 300 to 115,200 bps while sustaining real-time 4-20 mA HART loop protocol translation layer arrays via external gateway connections. Automated switching logic detects packet corruption or electrical line failure, executing port failover sequences to prevent signal degradation in high electrical noise fields.
Frequently Asked Questions
Q: What mechanisms trigger the automatic failover sequence between the serial ports?
A: Internal diagnostics track frame errors and bus voltage levels on the active port; if pre-set threshold faults are exceeded, a hardware line transfer forces the standby port to take over data processing.
Q: Can the physical signal lines be configured as half-duplex and full-duplex concurrently?
A: Port parameter routing determines whether the RS-422 or RS-485 interfaces operate in 2-wire half-duplex or 4-wire full-duplex layouts, though this must be locked during software configuration.
Q: How is the physical backplane insulation designed against cross-channel electrical faults?
A: The circuit board features onboard galvanic channel-to-channel isolation arrays that disconnect the underlying system logic components from hazardous field potentials up to the hardware rating.
Field Installation Guidelines
- Chassis Engagement: Slide the 1.81 kg module vertically into the dedicated carrier slot, confirming that the backplane pin layout is fully seated before closing the mechanical locking mechanisms.
- Grounding Requirements: Connect the grounding lug of the host carrier to the master instrument earth ground bus using a low-impedance copper cable conductor.
- Shield Termination: Terminate data line shields at a single point near the enclosure wall to stop common-mode voltage offsets from generating ground loops.
- Line Termination Resistance: Place physical 120 Ohm resistors across the terminal pairs at the end of long-distance RS-485 differential signals to suppress data packet reflection.