FS-TSDO-0824 Honeywell Safety Digital Output Module
Manufacturer: Honeywell
-
Part Number: FS-TSDO-0824
Condition：New with Original Package
Product Type: Digital Output Field Termination Assemblies
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
Honeywell FS-TSDO-0824 Safety Digital Output Module
Configured for safety-critical digital output execution in Honeywell safety architectures, the Honeywell FS-TSDO-0824 (FS-TSDO-0824 Safe Digital Output FTA Module) provides direct physical/electrical execution across field wiring networks.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | FS-TSDO-0824 |
| Brand | Honeywell |
| Origin | USA |
| Weight | 3 kg |
| Dimensions | 6 cm x 7 cm x 5.8 cm |
| Operating Temp | Standard Industrial Limits |
| Power Consumption | Max 36 VDC Operating Limit |
| Channel Capacity | 8 Digital Output Channels |
| Field Connection | Screw Terminals (Max 2.5 mm2 / AWG14, 0.5 Nm Torque) |
4-20 mA HART Loop Protocol and Channel-to-Channel Isolation
The hardware establishes secure galvanic isolation barriers between internal logic nodes and field wiring loops to prevent electrical surges from entering sensitive safety processors. Channel-to-channel isolation safeguards output paths against common-mode voltage spikes and ground potential loops. Furthermore, continuous loop diagnostic circuits track electrical integrity and terminal continuity across all eight sourcing outputs without disrupting active safety logic execution.
Frequently Asked Questions
Q: What are the terminal wiring and torque specifications for the FS-TSDO-0824 module?
A: The screw terminal block accommodates conductor sizes up to 2.5 mm2 (AWG14) with a recommended wire strip length of 7 mm and a tightening torque of 0.5 Nm (0.37 ft-lb).
Q: What maximum voltage rating applies to the output channels?
A: Each output channel supports a maximum operating limit of 36 VDC under IEC 1010:1990 Overvoltage Category 3 specifications.
Q: What DIN rail standards are compatible with the module housing?
A: The assembly mounts directly onto standard DIN EN rails, supporting both TS32 and TS35 x 7.5 profiles with a required rail length of 61 mm (2.40 inches).
Field Installation Guidelines
Snap the FTA module securely onto standard TS32 or TS35 x 7.5 DIN rails within the system cabinet. Connect the system cable from SICC-0001/Lx headers to the module socket, and route field wiring conductors through the designated screw terminal blocks. Tighten all field terminal screws to 0.5 Nm using an appropriately sized screwdriver. Ensure the enclosure ground connection is bonded directly to the cabinet earth bar with low-impedance copper grounding straps.