GE A20B-8101-0930/04A Communication Data Acquisition Module
Manufacturer: GE Fanuc
-
Part Number: A20B-8101-0930/04A
Condition：New with Original Package
Product Type: Communication Modules
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE A20B-8101-0930/04A Industrial Automation Module
The GE A20B-8101-0930/04A serves as the primary A20B-8101-0930 Communication / Data Acquisition Module utilized to execute high-speed data acquisition and protocol conversion across GE control platform networks.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | A20B-8101-0930/04A |
| Brand | GE |
| Origin | United States (USA) |
| Weight | 500 g |
| Dimensions | 100 mm x 80 mm x 20 mm |
| Operating Temp | -40 to +70 deg C |
| Power Consumption | Driven by 24 VDC industrial supply |
| Protocol Support | Modbus TCP/IP |
| Functions | Data acquisition, internal diagnostics, protocol conversion |
Industrial Control and Drive Technical Attributes
The architecture utilizes specialized circuitry optimized for backplane bus communication velocity parameters to process discrete data packets without communication lag. To sustain full performance during peak network loads and expansive I/O density scaling configurations, the hardware runs a dedicated internal diagnostic stack matching specific firmware flash compatibility matrices. The built-in interface operates over deterministic networks to maintain synchronous data routing while preventing multi-channel state degradation.
Frequently Asked Questions
Q: How is firmware flash compatibility verified on this hardware variant during deployment?
A: Verification must be carried out using system-level configuration software while the local processor is offline to avoid stopping live backplane bus communication velocity streams.
Q: Does the A20B-8101-0930/04A support live hot-swap installation inside an active control rack?
A: No, the power must be fully isolated before inserting or extracting the module to prevent electrical transients from disrupting the 24 VDC supply line or damaging data paths.
Field Installation Guidelines
- Mechanical Alignment: Slide the compact housing into the designated mounting slot inside the control enclosure. Tighten all hardware fasteners to establish a steady physical fit and support long-term mechanical balance.
- Power Connection Routing: Route the incoming 24 VDC industrial supply lines using separate physical pathways away from high-voltage AC motor wires to prevent capacitive noise coupling.
- Shield Grounding Control: Terminate all serial and network shield drain wires at a single clean earth grounding strip within the local cabinet layout to avoid forming circulating ground current loops.