GE DS200SDCIG1AGB Mark V Power Supply Module
Manufacturer: GE Fanuc
-
Part Number: DS200SDCIG1AGB
Condition：New with Original Package
Product Type: Power Supply Board
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE DS200SDCIG1AGB Mark V DC Power Supply and Instrumentation Board
Configured for power distribution and sensor signal conditioning in Mark V turbine control platforms, the GE DS200SDCIG1AGB (DS200SDCI DC Power Supply and Instrumentation Board) provides direct physical/electrical execution.
Suffix Breakdown & Model Matrix
| Base Model | Functional Revision A | Functional Revision G | Artwork Revision |
|---|---|---|---|
| DS200SDCIG1 | A | G | B |
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | DS200SDCIG1AGB |
| Brand | GE (General Electric) |
| Origin | USA |
| Weight | 1.2 kg (2.6 lbs) |
| Dimensions | Standard Mark V PCB Form Factor |
| Operating Temp | 0 to 60 deg C |
| Power Consumption | Dependent on backplane load |
| Functional Acronym | SDCI |
| Primary Functions | DC power regulation and instrumentation signal conditioning |
| Circuit Board Protection | Fuses FU1 through FU5 with LED fault status indicators |
| Configurable Jumpers | JP1 (MD output control), JP2 (AC contactor dropout time), SW1 (AC line burden selection) |
| Mounting Type | Rack or cage installation in Mark V drive/control cabinets |
| Interface Topology | Edge connectors and backplane bus for deterministic power and communication |
| Hot-Swap Support | Not supported (requires full power isolation prior to replacement) |
| Manual Reference | GEI-100173 |
Backplane Deterministic Network & Bus Execution
The board manages local power distribution and signal processing across the backplane bus interface to maintain deterministic control loops. Internal hardware design ensures stable power conversion for critical control circuitry while converting field instrumentation feedback into conditioned inputs. Hardware switch SW1 adjusts line burden characteristics, whereas jumpers JP1 and JP2 optimize driver outputs and contactor dropout latency within the host rack assembly.
Frequently Asked Questions
Q: Does the DS200SDCIG1AGB support hot-swap insertion during active system operation?
A: No, hot-swapping is not supported. Technicians must completely isolate all power sources to the drive cabinet or rack assembly before removing or replacing the board to prevent electrical arc hazards and damage to sensitive backplane components.
Q: How do the integrated fuse LEDs assist in troubleshooting field faults?
A: The board incorporates diagnostic LEDs associated with onboard fuses FU1 through FU5. A illuminated LED indicates a blown fuse condition, allowing maintenance personnel to quickly isolate overcurrent faults within specific DC distribution channels.
Q: Are hardware revisions critical when replacing an existing DS200SDCI board?
A: Yes, while the base function remains identical across the DS200SDCI series, the -AGB designation indicates functional revisions A and G along with artwork revision B. Installers must verify jumper settings JP1, JP2, and switch SW1 match the legacy module configuration prior to commissioning.
Field Installation Guidelines
- Isolate all AC and DC power feeds connected to the host Mark V frame prior to physical board removal or insertion.
- Wear a properly grounded wrist strap connected to the cabinet chassis to protect onboard semiconductors from electrostatic discharge.
- Verify proper engagement of all edge connectors and board guide rails before tightening mounting hardware.
- Align jumper settings JP1, JP2, and switch SW1 with the existing system configuration documentation prior to applying power.