GE Fanuc IC200ALG431 VersaMax Analog Mixed Module 0-10 VDC
Manufacturer: GE Fanuc
-
Part Number: IC200ALG431
Condition：New with Original Package
Product Type: Analog Mixed Modules
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE Fanuc IC200ALG431 VersaMax Analog Mixed Module
The GE Fanuc IC200ALG431 serves as the primary IC200ALG431 Analog Mixed Module utilized to execute 0-10 VDC signal acquisition and analog output generation across VersaMax platform networks. The hardware converts field voltage levels into 12-bit digital values for CPU processing while simultaneously generating proportional analog control voltages for end-device actuation.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | IC200ALG431 |
| Brand | GE Fanuc |
| Origin | USA |
| Weight | 0.37 kg |
| Dimensions | 3.5 cm x 13 cm x 13.5 cm |
| Operating Temp | 0 to 60 deg C |
| Power Consumption | 60 mA (Backplane current consumption) |
| Analog Inputs | 4 single-ended channels (0-10 VDC) |
| Analog Outputs | 2 single-ended channels (0-10 VDC) |
| Resolution | 12-bit (2.5 mV) |
| Input Filter Response Time | 5 ms |
| Input Impedance | 120 kΩ |
| Output Load Resistance | 5000 Ω minimum |
| Output Capacitor Load Limit | 1 µF |
| Isolation | 1500 V (field side to logic side) |
Backplane Bus Communication and Firmware Flash Compatibility
Integrating directly onto the VersaMax carrier base, the module leverages high-speed backplane bus communication to transfer 12-bit digital conversions to the main CPU within standard scan cycles. Firmware flash compatibility permits routine updates to the analog-to-digital conversion algorithms without requiring physical hardware alterations. I/O density scaling operates efficiently by consolidating four input loops and two output loops into a single hardware footprint, thereby optimizing the internal bus power distribution.
Frequently Asked Questions
Q: What is the backplane current draw for this analog module?
A: The IC200ALG431 consumes 60 mA from the internal backplane logic power supply during standard operation.
Q: Does the module support current loop signals like 4-20 mA?
A: No, this specific hardware configuration processes strictly 0-10 VDC single-ended voltage signals for both the input and output channels.
Q: What happens if the field device attached to the output exceeds the capacitor load limit?
A: Driving a capacitive load greater than 1 µF induces instability in the output amplifier circuitry, resulting in signal oscillation and delayed step-response settling times.
Field Installation Guidelines
Secure the module carrier base to a grounded 35 mm DIN rail or panel grid prior to inserting the I/O block. Terminate the 0-10 VDC field wiring utilizing shielded twisted pair cables. Route the cable drain wires to a single-point earth ground lug at the control panel to eliminate ground loop currents. Separate all low-voltage analog cables from AC power lines or high-frequency motor drive cables in the physical wireways. Verify that connected field devices maintain a minimum load resistance of 5000 ohms on the output channels to prevent signal attenuation.