GE Fanuc IC695ALG728 PACSystems RX3i 8-Channel AO Module
Manufacturer: GE Fanuc
-
Part Number: IC695ALG728
Condition：New with Original Package
Product Type: Analog Output Modules
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE Fanuc IC695ALG728 PACSystems RX3i Series
Configured for high-accuracy voltage and current loop execution in PACSystems RX3i platforms, the GE Fanuc IC695ALG728 (IC695ALG728 Analog Output Module) provides direct physical/electrical execution.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | IC695ALG728 |
| Brand | GE Fanuc |
| Origin | United States (USA) |
| Weight | 0.22 kg |
| Dimensions | 142 mm x 100 mm x 34 mm |
| Operating Temp | -40 to +70 deg C |
| Power Consumption | 500 mA @ 5 VDC |
| Output Channels | 8 analog output channels (non-isolated, shared common) |
| Output Types | 0 to 10 VDC, 4 to 20 mA (with superimposed HART) |
| Resolution | 16-bit Digital-to-Analog conversion |
| Certifications | UL, CE, ATEX Zone 2, CSA, Marine (ABS, BV, DNV, GL, KRS, LR) |
| Storage Temp | -40 to +85 deg C |
Industrial Control and Drive Technical Attributes
The architecture links multiple analog loops directly to the RX3i chassis while managing data alignment alongside preset backplane bus communication velocity parameters. To ensure uninterrupted command execution during heavy multi-channel scaling and dense I/O density scaling profiles, the digital processing engine syncs field-side variables with current firmware flash compatibility versions. The integrated circuitry enables real-time device diagnostic transmission across deterministic networks, supporting HART digital messaging over the analog current path without altering standard output loop response.
Frequently Asked Questions
Q: How does the module prevent register data loss during standard firmware flash compatibility synchronization?
A: System engineers must fully halt the active controller execution path and disconnect active field wiring blocks before starting a firmware update sequence to avoid corruption across the backplane bus communication velocity rails.
Q: Is online hot-swap module replacement supported for the IC695ALG728 within an active RX3i rack layout?
A: While the PACSystems RX3i backplane permits hot-swapping under specific software configurations, field safety steps require isolating external 4 to 20 mA loops prior to extraction to prevent high-current transients across the shared common reference.
Field Installation Guidelines
- Chassis Insertion and Connector Engagement: Slide the module firmly into the targeted RX3i slot assignment. Ensure the upper and lower plastic retaining clips engage fully with the chassis perimeter rail to preserve proper structural balance under vibration.
- HART Loop Shield Continuity: Terminate all external twisted-pair signal loop shields at the designated cabinet grounding block. Avoid tying shields to the module common terminals to limit noise ingress into the 16-bit D/A converters.
- Conductor Separation and Routing: Route the 8-channel analog signal lines through isolated low-voltage wire guides, maintaining physical distance from parallel high-voltage AC motor lines.