GE IC695PSD040J PACSystems RX3i 40W Power Supply Module
Manufacturer: GE Fanuc
-
Part Number: IC695PSD040J
Condition：New with Original Package
Product Type: Power Supply Modules
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE Fanuc IC695PSD040J PACSystems RX3i Power Supply Module
Configured for primary power conversion in PACSystems RX3i platforms, the GE Fanuc IC695PSD040J (IC695PSD040 Power Supply Module) provides direct physical/electrical execution. The unit accepts a 24 VDC nominal input (18 to 30 VDC operational range, starting at 12 to 30 VDC) to output 40 W total DC power across internal 5.1 VDC and 3.3 VDC buses. Mounting directly in the power supply slot of an RX3i universal backplane, it distributes logic power to CPU and I/O modules across the rack.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | IC695PSD040J |
| Brand | GE Fanuc |
| Origin | United States |
| Weight | 0.60 kg (1.31 lbs) |
| Dimensions | 2.1 cm x 18.8 cm x 26.2 cm |
| Operating Temp | 0 to 60 deg C |
| Power Consumption | 60 W maximum input power |
| Input Voltage Range | 18 to 30 VDC (Run: 12 to 30 VDC) |
| Output Power | 40 W total maximum |
| Output Bus Voltages | 5.1 VDC (0 to 6 A); 3.3 VDC (0 to 9 A) |
| Inrush Current | 4 A peak, 100 ms maximum |
| Ride Through Time | 10 ms |
| Status Indicators | 4 LEDs |
Backplane Bus Communication Velocity and Power Distribution
The IC695PSD040J delivers regulated power directly to the RX3i universal backplane high-speed bus structure to maintain backplane bus communication velocity across adjacent expansion and I/O slots. Firmware flash compatibility across the RX3i platform ensures proper system startup handshaking as the supply brings the 5.1 VDC rail (up to 6 A) and 3.3 VDC rail (up to 9 A) within active tolerances. An onboard ON/OFF switch allows localized power isolation without disconnecting the front terminal block wiring.
Frequently Asked Questions
Q: Can two IC695PSD040J modules be wired together to increase total rack power output?
A: Up to two PSD040 modules can be daisy-chained on a universal baseplate for increased capacity mode, provided the backplane configuration supports dual power supply routing.
Q: What wire size range is recommended for the terminal block on the IC695PSD040J?
A: The input wiring terminals accept solid or stranded copper conductors ranging from 14 AWG to 18 AWG, rated for terminal currents up to 6 A.
Q: Does the IC695PSD040J support controller or power supply redundancy?
A: No, this module does not support hardware power supply redundancy or controller redundancy configurations; it operates strictly as a standard 40 W rack power source.
Field Installation Guidelines
Disconnect main DC feed power before attempting installation or removal of the IC695PSD040J module from the RX3i rack. Insert the module into the dedicated power supply slot on the left end of the RX3i universal backplane, ensuring the rear backplane connectors line up accurately before pushing firmly until the module latches into place.
Wire the 24 VDC input lines to the removable terminal strip using 14 AWG to 18 AWG copper conductors, taking care to observe correct polarity. Connect the frame ground terminal directly to the central panel earth ground bar using a low-impedance conductor to protect internal logic circuits against electrical fast transients and high-frequency noise interference.