GE IS200VRTDH1D Mark VI VRTD Terminal Board
Manufacturer: GE Fanuc
-
Part Number: IS200VRTDH1D
Condition：New with Original Package
Product Type: Input Boards
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE IS200VRTDH1D VRTD Terminal Board
Configured for high-precision sensor signal termination in Mark VI turbine control platforms, the GE IS200VRTDH1D (IS200VRTDH1D VRTD Terminal Board) provides direct physical/electrical execution of RTD and vibration probe signal routing.
Suffix Breakdown & Model Matrix
| Model Suffix | Functional Variant |
|---|---|
| IS200VRTDH1D | Standard VRTD Terminal Board (Baseline) |
| IS200VRTDH1DAB | Revision variant with refined field terminal layout |
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | IS200VRTDH1D |
| Brand | General Electric |
| Origin | USA |
| Weight | 0.30 kg |
| Dimensions | 233 x 160 mm |
| Operating Temp | -40 deg C to +70 deg C |
| Power Consumption | < 12 W |
| Signal Capacity | 16 channels (board-dependent) |
| Isolation | Channel-to-channel and channel-to-system |
| Interface | Ribbon cable to TRTD I/O pack |
Industrial Control and Firmware Synchronization
The IS200VRTDH1D functions as the primary field interface for the TRTD I/O pack within the Mark VI architecture. The board employs low-noise filtering and lead-wire compensation to maintain signal integrity before the TRTD pack performs 14-bit A/D conversion. Deterministic data exchange depends on correct I/O density scaling; users must verify that the TRTD firmware flash compatibility supports the specific channel configuration connected to the terminal board. Misconfiguration of RTD lead-wire settings or polarity will introduce measurement drift in the turbine monitoring algorithms.
Frequently Asked Questions
Q: Can the IS200VRTDH1D be replaced while the TRTD I/O pack is powered?
A: While the board does not contain active processing logic, it is recommended to de-energize the associated TRTD I/O pack before removing the ribbon cable connection to prevent potential electrostatic discharge (ESD) or transient voltage spikes on the analog input channels.
Q: Is this board compatible with legacy Mark VI H1A or H1B configurations?
A: Compatibility is limited. The H1D revision features updated hardware components for improved stability. Replacement of legacy H1A/H1B units with an H1D board requires verification of the system loop calibration to ensure measurement accuracy.
Field Installation Guidelines
- Mounting: Secure the board within the Mark VI rack chassis using the integrated mounting holes. Ensure proper bonding to the chassis ground to maintain the effectiveness of the channel-to-channel isolation.
- Sensor Wiring: Terminate 3-wire or 4-wire RTDs using the specified screw-type terminals. Tighten terminals to the recommended torque to minimize contact resistance, which directly impacts the lead-wire compensation accuracy.
- Shielding: Field cabling must utilize shielded twisted-pair conductors. Ground the cable shields at the cabinet entry point using a low-impedance connection to prevent ground loops and high-frequency interference.
- Inspection: Inspect the conformal coating for integrity during installation. If the board is used in environments with salt-fog or chemical contaminants, ensure the protective layer is intact to prevent copper trace corrosion.