Honeywell 51195153-901 Double Shielded RG-6 Drop Set

Product Overview

The Honeywell 51195153-901 (51195153901) functions as a specialized RG-6 coaxial drop cable set engineered for the Universal Control Network (UCN). This 100% brand new, original cable facilitates high-speed signal transmission between Input/Output Processors (IOP), Field Termination Assemblies (FTA), and other critical nodes within the Honeywell TDC 3000 Distributed Control System (DCS). Spanning 1.5 meters in length, this pre-terminated lead provides the essential link for short-range module interconnections. It maintains network integrity by utilizing a high-performance coaxial architecture designed specifically for the deterministic communication requirements of industrial control environments.

Technical Specifications

The 51195153-901 adheres to rigorous industrial networking standards to ensure zero-packet-loss communication.

Engineering Advantages

The Honeywell 51195153-901 solves specific signal attenuation and noise challenges in industrial control racks:

• Superior EMI Mitigation: The double-shielded design provides a formidable barrier against electromagnetic interference (EMI) and radio frequency interference (RFI). This allows the cable to maintain signal clarity even when routed near high-voltage motor starters or variable frequency drives (VFDs) inside the control cabinet.

• Precision Signal Impedance: By maintaining a consistent 75-ohm impedance, the cable eliminates signal reflections that cause data corruption in high-speed UCN loops. This ensures the IOP receives clean data packets, reducing network retries and improving overall DCS scan rates.

• Reduced Installation Latency: The pre-terminated BNC connectors eliminate the need for field crimping, which often introduces high-resistance points or cold-solder joints. This "plug-and-play" capability accelerates commissioning and ensures a professional-grade connection that withstands vibration.

• Optimized Rack Geometry: At 1.5 meters, the cable provides sufficient slack for clean routing through wire ducts without excessive looping. This promotes better airflow within the cabinet and reduces physical stress on the I/O processor's connection ports.

FAQs

• Can I use standard commercial RG-6 cable to replace the 51195153-901?

  We strictly advise against using non-industrial cables. The 51195153-901 undergoes specific system testing by Honeywell to meet the precise timing and shielding requirements of the UCN. Standard commercial cables often lack the necessary shielding density, potentially leading to intermittent network errors or IOP failure.

• Does this cable set include both ends of the connection?

  Yes, the 51195153-901 is a complete drop cable set, pre-terminated at both ends for immediate connection between your UCN tap or trunk and the specific module interface.

• What is the maximum bending radius for this RG-6 drop cable?

  To prevent signal degradation or internal conductor damage, maintain a minimum bending radius of at least 3 inches (approx. 7.5 cm) during installation and routing within the ducting.

• Is this cable compatible with the newer Experion PKS UCN interfaces?

  Yes, this cable remains the standard interconnection for any Honeywell system utilizing the Universal Control Network (UCN) physical layer, including legacy TDC 3000 and upgraded Experion platforms.