Honeywell CC-TAIX61 Series 8 Redundant Analog Input Module
Manufacturer: Honeywell
Condition：New with Original Package
Product Type: Analog Input Modules
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
Honeywell CC-TAIX61 Series 8 Module
The Honeywell CC-TAIX61, also cataloged as the CC-TAIX61 Redundant Analog Input IOTA, operates as a dedicated hardware component for isolated analog signal acquisition within Experion PKS, C300, and TPS/TDC 3000 platforms.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | CC-TAIX61 (Part Number 51307077-175) |
| Brand | Honeywell |
| Origin | USA |
| Weight | 0.6 kg |
| Dimensions | 267 x 178 x 52 mm |
| Operating Temp | -40 to +70 deg C |
| Power Consumption | Approx. 10 W |
| Module Type | Redundant Analog Input IOTA (Series 8) |
| Number of Channels | 16 analog input channels |
| Input Signal Types | 4-20 mA, 0-20 mA, 0-10 V, +/-10 V |
| Resolution | 16-bit A/D conversion |
| Accuracy | +/-0.1% to +/-0.2% of full scale |
| Input Impedance | > 250 ohm (current), > 1 M ohm (voltage) |
| Isolation | 2500 Vrms channel-to-backplane galvanic isolation |
| Scan Time | <= 50 ms per channel |
| Power Supply | 24 VDC |
| Environmental Protection | G3 conformal coating (corrosion-resistant) |
Process Control & DCS Instrumentation Properties
Operating within the Honeywell Experion PKS architecture, this execution unit integrates 2500 Vrms channel-to-backplane galvanic isolation parameters to suppress field ground loops and protect system backplane processing layers. The component digitizes incoming signals through high-accuracy 16-bit converters, maintaining field compatibility with 4-20 mA HART loop protocol transmitters as well as multiple voltage levels (+/-10 V and 0-10 V). It supports 1:1 redundant configurations on specialized Input Output Termination Assemblies (IOTA), providing deterministic scanning across all 16 channels within a maximum window of 50 ms per channel.
Frequently Asked Questions
Q: Does the CC-TAIX61 support online module replacement during active process operations?
A: Yes. The hardware fully supports hot-swap operations, allowing a faulty analog input module to be removed and replaced without interrupting field loop tracking or dropping system backplane power.
Q: What environmental classification does the module circuit board carry?
A: The board features standard factory-applied G3 conformal coating, which matches harsh industrial environments by preventing premature oxidation and corrosion from ambient humidity and chemical contaminants.
Q: How does the module handle a field wire break or signal drop below 4 mA?
A: The internal diagnostics perform automatic open-circuit and under-range/over-range tracking, sending fault registers to the C300 controller baseplate to block invalid data transmission.
Field Installation Guidelines
Mount the Series 8 IOTA baseplate assembly directly to a clean, grounded standard DIN rail within the instrument termination enclosure. Before fitting the CC-TAIX61 hardware module into its active termination position, confirm that the 24 VDC system power rail matches nominal tracking values. Terminate all multi-range voltage loops and 4-20 mA input cables at the screw terminal arrays using shielded twisted-pair conductors. Bond all cable shields to the designated instrument ground bus bar inside the enclosure at a single termination point; do not allow dual-end shield paths to prevent ground currents from interfering with the 16-bit analog translation phase.