IC693CPU374-AS GE 133MHz Embedded Ethernet CPU
Manufacturer: GE Fanuc
-
Part Number: IC693CPU374-AS
Condition：New with Original Package
Product Type: CPU Processors
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE IC693CPU374-AS Series 90-30 PLC
The GE IC693CPU374-AS, also cataloged as the IC693CPU374 Processor Module, serves as the primary IC693CPU374 Processor Module utilized to execute complex logic programs across Series 90-30 PLC platforms.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | IC693CPU374-AS |
| Brand | GE |
| Origin | United States (USA) |
| Weight | Standard single-slot module weight baseline |
| Dimensions | Single-slot width form factor |
| Operating Temp | 0 to +60 deg C |
| Power Consumption | Derived from backplane power rail lines |
| Processor Speed | 133 MHz |
| Typical Scan Rate | 0.15 ms per 1K Boolean logic |
| User Memory | 240 KB configurable user memory (battery-backed RAM) |
| Communication | Dual embedded Ethernet 10/100 Mbps ports with built-in switch |
| I/O Capacity | Up to 4K I/O points across 8 expansion racks |
Industrial Control and Drive Technical Attributes
The processing architecture handles direct bit and word transfers while regulating the master backplane bus communication velocity indexes across connected expansion racks. To sustain low jitter during intense logical loops and large-scale I/O density scaling routines, the embedded Ethernet controller coordinates directly with the main logic stack using specific firmware flash compatibility matrices. These multi-port physical layer interfaces function on deterministic networks, passing SCADA or DCS telemetry registers without inducing data latency or task execution stalling.
Frequently Asked Questions
Q: How can field engineers manage program safety parameters during firmware flash compatibility alignment tasks?
A: Engineers must completely isolate the processing block from the active expansion racks and backplane bus communication velocity channels before executing firmware transfers to prevent register corruption.
Q: Is online hot-swap card insertion supported for this primary processor card?
A: No, hot-swapping the primary processor is prohibited; the master baseplate power supply lines must be isolated before physical insertion or extraction to protect the system memory circuits from damage.
Field Installation Guidelines
- Chassis Engagement and Hook Seating: Insert the single-slot processor card straight into the slot 1 allocation on the PLC master baseplate. Pivot the upper and lower latching tabs until they lock completely into the frame.
- Dual Ethernet Network Topology: Route network cables via the integrated 10/100 Mbps switch ports. Maintain proper bend radii to ensure long-term structural balance and prevent interface connection failures.
- Battery Module Backing Check: Verify the battery retention cable linkage is fully mated with the internal processor cell connector prior to downloading runtime memory maps.