Power Supply Module | GE IC695PSD140E PACSystems RX3i
Manufacturer: GE Fanuc
-
Part Number: IC695PSD140E
Condition：New with Original Package
Product Type: Power Supply Modules
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
GE Fanuc IC695PSD140E PACSystems RX3i Expansion Power Supply
The GE Fanuc IC695PSD140E, also cataloged as the IC695PSD140 Expansion Power Supply Module, operates as a dedicated hardware component for converting 24 VDC input voltage into regulated backplane power within PACSystems RX3i expansion and remote base platforms.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | IC695PSD140E (Base Model: IC695PSD140) |
| Brand | GE Fanuc |
| Origin | USA |
| Weight | 0.30 kg (0.57 lbs) |
| Dimensions | 3.8 cm x 14.0 cm x 14.0 cm (1.5 in x 5.5 in x 5.5 in) |
| Operating Temp | 0 deg C to 60 deg C |
| Power Consumption | Approximately 6.0 A at 24 VDC input (60 W maximum input power) |
| Output Power Rating | 40 W / 140 W system rated output capacity |
| Nominal Input Voltage | 24 VDC nominal |
| Input Voltage Range | 18 VDC to 30 VDC |
| Bus Output Voltages | +5.1 VDC (+5 VDC regulated) and +3.3 VDC |
| Protection Features | Overcurrent protection, overvoltage protection, and thermal shutdown |
| Isolation Rating | 1500 V RMS between input circuits and backplane logic |
| Diagnostic Indicators | Front-panel LEDs for Power OK, Fault status, and Redundancy state |
| Chassis Placement | Dedicated power supply slot in RX3i remote and expansion racks |
Deterministic Backplane Execution & Power Regulation
Installing the GE Fanuc IC695PSD140E into dedicated RX3i chassis slots ensures stable voltage delivery to local expansion modules while maintaining backplane bus communication velocity across high-density I/O platforms. The integrated power conversion circuitry delivers low-ripple output logic power directly across the internal backplane, preserving signal integrity and firmware flash compatibility for attached communication adapters. Front-panel status indicators continuously monitor thermal status and input thresholds to protect connected rack components from line transients.
Frequently Asked Questions
Q: Can technicians install this module in a main CPU rack?
A: No, the module is engineered specifically for installation in dedicated power supply slots on PACSystems RX3i remote and expansion bases.
Q: How does the internal isolation circuit handle ground potential differences?
A: The module incorporates internal galvanic isolation rated for 1500 V RMS between the incoming 24 VDC input terminals and the internal backplane logic ground.
Field Installation Guidelines
Turn off system power before inserting the power module into the designated power supply slot of the expansion base. Ensure all incoming 24 VDC power wiring connects securely to the screw terminal block, observing correct polarity to avoid input fault conditions. Ground the expansion chassis properly using a heavy-gauge copper conductor tied to the main panel protective earth bar to maintain surge protection performance and reduce common-mode noise.