Safety Manager Cable Assemblies | Honeywell FC-SICC-0001/L10
Manufacturer: HONEYWELL
-
Part Number: FC-SICC-0001/L10
Condition：New with Original Package
Product Type: Cable Assemblies
-
Country of Origin: Sweden
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
Honeywell FC-SICC-0001/L10 Safety Manager Cable Assembly
Configured for digital input communication in Safety Instrumented Systems (SIS), the Honeywell FC-SICC-0001/L10 (FC-SICC-0001 Safety Instrumented Control Cable Assembly) provides direct physical/electrical execution. The component routes signal lines between SDI modules and Field Termination Assemblies (FTAs) to maintain technical continuity under deterministic conditions across safety logic systems.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | FC-SICC-0001/L10 |
| Brand | Honeywell |
| Origin | Factory standard |
| Weight | Standard technical package |
| Dimensions | 10 meters (L10 length designation) |
| Operating Temp | -20 to +60 deg C |
| Power Consumption | Passive conduction (<= 2 mA per channel) |
| Cable Type | Shielded multi-core control cable |
| Connector Type | Factory-terminated plug connectors |
| Number of Conductors | 16 pairs (for 16 digital input channels) |
| Conductor Size | 0.5 - 0.75 mm2 |
| Shielding Structure | Overall foil shield with drain wire |
| Voltage Rating | 24 VDC digital input signals |
| Insulation Material | PVC or equivalent flame-retardant compound |
| Humidity Range | 5% - 95% non-condensing |
| System Compatibility | Honeywell Safety Manager, SIS, BMS |
| Certifications | CE, UL, CSA, TUV |
Process Control & Channel Isolation
The multi-core architecture embeds 16 isolated twisted pairs tailored to insulate low-current digital signaling from high-frequency interference fields. The overall foil shield grounding matrix acts directly to suppress electromagnetic noise, preserving loop telemetry validation during active diagnostic sweeps. Physical separation of the internal conductors achieves stable channel-to-channel isolation, preventing signal degradation or current leakage from disrupting parallel 4-20 mA HART loop protocol architectures operating inside the same terminal panel assembly.
Frequently Asked Questions
Q: Does the assembly support hot-swap replacement while the safety controller remains online?
A: Physical replacement of the I/O connection card interfaces must occur only when the specific loop node is bypassed or deactivated inside the Safety Manager software to avoid generating transient signal spikes.
Q: How is the overall foil shield drain wire integrated into the safety cabinet earthing matrix?
A: The factory-terminated drain wire must connect directly to the instrumentation clean earth rail at the sub-rack side to achieve optimal EMC noise diversion and path protection.
Q: Can this cable assembly route high-voltage AC output signals if required?
A: No, the hardware remains limited to low-voltage 24 VDC digital input signal lines with a strict rated current threshold of less than or equal to 2 mA per channel.
Field Installation Guidelines
- Verify that the physical model marking matches the target terminal block allocation before inserting factory-terminated plugs.
- Check the alignment of the connector pins with the SDI module interface to prevent crushing contacts during seating procedures.
- Ground the overall foil shield at one terminal point only to prevent ground loop currents across the 10-meter span.
- Maintain standard bending radii for the multi-core bundle to prevent tearing the foil shielding or stretching the inner core conductors.