Siemens 6FX2001-5FN13 PROFINET Absolute Encoder
Manufacturer: Siemens
-
Part Number: 6FX2001-5FN13
Condition：New with Original Package
Product Type: Absolute Encoders
-
Country of Origin: USA
Payment:T/T, Western Union
Shipping port: Xiamen
Warranty: 12 months
Siemens 6FX2001-5FN13 Absolute Encoder
Configured for high-resolution angular position tracking in SINUMERIK, SIMODRIVE, and SINAMICS motion drive architectures, the Siemens 6FX2001-5FN13 (6FX2001-5FN13 Single-Turn Absolute Encoder) provides direct physical/electrical execution across PROFINET deterministic networks. The unit converts dynamic shaft position data into digital PROFINET frames with 16-bit resolution, enabling real-time closed-loop feedback for CNC spindles and robotic axes. Physical coupling utilizes a standard 6 mm solid synchronous shaft configured for direct radial flange insertion. Powering occurs via an internal wide-range power input circuit operating from 10 VDC to 30 VDC.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | 6FX2001-5FN13 |
| Brand | Siemens |
| Origin | Germany |
| Weight | 0.413 kg |
| Dimensions | Standard 6 mm solid shaft design |
| Operating Temp | Up to 85 deg C |
| Power Consumption | Operating supply range 10-30 VDC |
| Product Type | Single-Turn Absolute Encoder |
| Resolution | 16-bit |
| Interface | PROFINET IO |
| Connector Type | M12 radial plug |
| Shaft Type | Synchronous shaft, 6 mm diameter |
| Compliance | RoHS, WEEE |
Deterministic Backplane Bus Communication Velocity and Firmware Compatibility
To achieve deterministic cycle times in high-speed CNC applications, the internal communication logic utilizes high-speed PROFINET hardware scaling. This setup eliminates signal jitter across distributed motion nodes. The encoder firmware flash compatibility layer enables seamless parameter synchronization with SINUMERIK motion controllers and SINAMICS drive modules. Internal register structures maintain position data integrity during high rotational acceleration while isolated transceiver stages prevent field bus noise injection.
Frequently Asked Questions
Q: What power input range is supported by the internal transceiver module?
A: The encoder operates from an active supply rail of 10 VDC to 30 VDC, incorporating reverse polarity protection to prevent component failure during wiring installation.
Q: How is the fieldbus physical interface wired on this unit?
A: Fieldbus connectivity uses an integrated M12 radial plug connector configured for PROFINET communication cables, maintaining interference-free digital signal transmission.
Q: Does the encoder maintain position integrity under high thermal operating limits?
A: The internal optical scanning assembly and signal conditioning circuitry maintain rated 16-bit positioning performance up to a maximum ambient temperature of 85 deg C.
Field Installation Guidelines
Mounting requires proper alignment of the 6 mm synchronous shaft using flexible mechanical couplings to minimize axial and radial load stresses on the internal bearings. System integrators must verify full flange engagement before securing the mounting hardware.
Connect the M12 radial plug using pre-assembled double-shielded PROFINET cabling. Route the signal lines away from high-voltage motor leads to mitigate electromagnetic interference. Ensure the outer cable shield makes 360-degree continuous contact with the connector housing, providing low-impedance grounding directly to the equipment chassis earth.